Rendering issue
Posted: Wed Jan 24, 2024 9:37 am
Twilight render stops after just few seconds of starting rendering, stating that render complete, please what could be responsible
Fletch wrote: ↑Tue Nov 28, 2023 1:28 pmthis is the likely culprit - I'm not sure what you mean by "dome lights" but light emitting surfaces increase render times.I have some dome lights inside that are light emitters.
hi resolution textures can increase render timesapplied two different siding textures to the exterior walls,
I would not add emitter fill lights to "help" the sun/sky, but rather I would use Filmic post process in the Lower Right corner of the Render Dialog.
Subject: ACES vs Filmic : When do I use Filmic versus ACES when Tonemapping?
Verify that you have not accidentally applied a Light Emitter template to any materials in your scene.
Use Extensions>Twilight V2>Diagnostic and run that on the entire scene - read about your textures and lights in your scene in the diagnostic results it should tell you where you may have accidentally applied light emitter to a material or have high resolution textures where they may not be necessary.